Parts bought or acquired for the restoration

Looking at this list now (and I keep on adding to it!) makes me realize just how incomplete the Ape was when we got it!

Malossi 112cc kit (cylinder/piston etc.)
Reconditioned crank
16/68 gear kit
V50 gearbox gears & kickstart gear
Main bearing and seal kit
Complete clutch assembly (multi-spring to cope with 112cc kit)
Gasket set
Air filter assembly
Spark plug
Flywheel/stator assembly (for 12v lighting & elect ignition)
Electronic ignition coil
DellOrto SHBC 18:16 carb
Petrol tank
Petrol tap
Drive shaft boots and oil seals
Control cables (throttle, clutch, reverse, choke)
Front mudguard
Handlebar light switches
Various lights (rear, indicators etc)
Speedo (from PK125)
Speedo cable
Windscreen washer kit
8'x4' sheet of 20swg mild steel (for bodywork repairs)
Wheel rim & tyre (as spare)

Parts from a contact in Austria:
3 new dampers
Door handles
Headlight (second hand but original!)
More control cables
Rear brakes, wheel cylinders & master cylinder
Ignition switch

We also have a 'donor car' (actually a Fiat Uno MOT failure) which we have taken the following parts from:
Drivers seat
Seat belt
Rear windscreen wiper motor, arm etc.
Petrol tank filler tube & cap
Jack

More recently, we have bought:
Primary gear kit (PK125)
Bearings for drive shaft hub
New tyres
Exhaust, PK125 with modified downpipe
Later engine, with electric start & 2-stroke oil feed
12V regulator

If you have reached this page via a search engine, you may not see the whole site.
Click here to go to the main site